Toshiba e-studio355 Troubleshooting Manual page 49

1.TROUBLESHOOTING FOR THE HARDWARE
Saddle Stitch Finisher MJ-1025
1
Open the front cover of the finisher.
2
Pull out the stapler unit holding the green handle.
3
Turn the top green knob clockwise until the triangle
mark and the rectangular mark are aligned as shown
in the figure on the right, so that the stapler is pulled
out toward you.
4
Take out the staple cartridge holding its green portion
on both sides.
5
Raise the guide while holding the knob.
1 TROUBLESHOOTING FOR THE HARDWARE
Clearing a Staple Jam 47