Foxconn Renaissance User Manual page 113

2. Copy section 5-2, BIOS Configuration.
Shut down the computer, connect SATA hard disks to SATA ports, power on
computer again.
Press <Del> key, get into BIOS, set SATA mode to [RAID], press <F10> to save and
exit BIOS. PC will reboot.
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
IDE Configuration
Configure SATA#1 as
► Primary IDE Master
► Primary IDE Slave
► Secondary IDE Master
► Secondary IDE Slave
Hot Plug
Hard Disk Write Protect
IDE Detect Out
↑↓←→:Move Enter:Select
3. Copy section 5-3, Create RAID in BIOS.
Press <CTRL><I> simultaneously to get into RAID BIOS set up (Intel
Storage Manager option ROM utility).
Configure your new hard disks to RAID0, 1, 5 or 10. Exit RAID BIOS. PC will reboot.
4. The Windows XP is running again and a new hardware of RAID disk was found.
Click [Cancel] to skip this Wizard.
IDE Configuration
[RAID]
[RAID]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Disabled]
[Disabled]
[35]
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
106
Help Item
Options
IDE
RAID
AHCI
F1:General Help
®
Matrix
Click to exit.