Advertisement
3. S
ETUP
AC Power
To determine the power requirements for a particular fixture, see the label affixed to the
back plate of the fixture or refer to the fixture's specifications chart. All fixtures must be
powered directly off a switched circuit and cannot be run off a rheostat (variable resistor)
or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0–100%
switch. Before applying power to a fixture, check that the source voltage matches the
fixture's requirement.
All fixtures must be connected to circuits with a suitable Earth Ground.
Mounting
Orientation
Rigging
Mini Strobe LED User Manual
This fixture may be mounted in any safe position.
The fixture includes a mounting yoke to which a rigging clamp can be attached.
You must make sure the clamp is capable of supporting the weight of this fixture.
You can order "C" and "O" clamps from any CHAUVET® dealer or distributor
(CLP-02, CLP-10 recommended).
There are 2 types of mounting options for this fixture: floor stand for up
lighting, and overhead use for down lighting. You must use at least one (1)
safety cable/chain for each fixture in addition to the mounting clamp.
If hanging the fixture for overhead use, please follow the steps below.
1. Block access below the work area and use a suitable and stable platform
when installing or servicing fixture.
2. Safety cables must always be used. The safety cable must be capable of
holding 10 times the weight of the fixture.
3. Verify the structure can hold 10 times the weight of all to-be installed fixtures.
Hanging clamp sold separately.
Hanging Clamp
Sold separately
5
Rev. 3
Advertisement
