Superio Configuration - Foxconn A7GM-S User Manual

This item is used to set the transmission rate mode of USB 2.0. The available settings are :
[HiSpeed] in 480Mbps; [Full Speed] in 12Mbps.
► BIOS EHCI Hand-Off
Windows XP supports a number of features in the Enhanced Host Controller Interface (EHCI)
specification, but there are a few features that are not implemented. Microsoft said preliminary
support for EHCI BIOS handoff will be available in Windows XP SP2.
This item allows you to enable support for OS without EHCI hand-off feature.
This is a workaround for OS without EHCI hand-Off support .
The EHCI ownership change should claim by EHCI driver.
If USB devices are connected to the computer, the following item will appear:
► USB Storage Configuration
After pressing <Enter>, you can set the reset delay for the USB mass storage device. There
are many different emulation types of this USB device, such as floppy, hard disk and CDROM
can be selected.

SuperIO Configuration

CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
SuperIO Configuration
Onboard Floppy Controller
Serial Port Address
IR Address
IR Mode
IR Duplex Mode
↑↓←→:Move Enter:Select
► Onboard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► IR Address
This item is used to assign the I/O address and interrupt request (IRQ) for the IR port.
► IR Mode
This item is used to set the IR mode. The available settings are :
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASK IR] : A faster IrDA for 1152000 bit/s.
► IR Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
SuperIO Configuration
[Enabled] [Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[IrDA]
[Half Duplex]
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
39
Help Item
Allows BIOS to Enable
or Disable Floppy
controller.
F1:General Help