Superio Configuration; Onboard Floppy Controller - Foxconn A78AX-K User Manual

SuperIO Configuration

SuperIO Configuration SuperIO Configuration

OnBoard Floppy Controller

Serial Port1 Address
Serial Port2 Address Serial Port2 Address
Serial Port2 Mode Serial Port2 Mode
Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
↑↓←→:Move
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► Serial Port2 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 2.
► Serial Port2 Mode
This item is used to set the mode for the onboard serial port 2. The available settings are :
[Normal] : RS232 Mode.
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASK IR] : A faster IrDA for 1152000 bit/s.
► Serial Port2 Duplex Mode
When "Serial Port2 Mode" is set to "IrDA" or "ASK IR", this item will appear. It is used to set the
transfer mode of the onboard serial port 2. The available settings are : [Half Duplex],
[Full Duplex].
► Parallel Port Address
This item is used to assign the I/O address for the onboard parallel (or Printer) port.
► Parallel Port Mode
This item is used to set the mode for the onboard parallel (or Printer) port.
► Parallel Port IRQ
This item is used to assign interrupt request (IRQ) for the onboard parallel (or Printer) port.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
SuperIO Configuration
Mode
Enter:Select
F1:General Help
Help Item
[Enabled]
[Enabled] Allows BIOS to Enable
[3F8/IRQ4] or disable floppy
[2F8/IRQ3] controller.
[Normal] [Normal] [Normal]
[378]
[Normal]
[IRQ7]
+/-/:Value F10:Save
F9:Optimized Defaults
38
ESC:Exit
The available settings are :