Ide Configuration - Foxconn A78AX-K User Manual

IDE Configuration

CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
IDE Configuration IDE Configuration
OnBoard PCI IDE Controller
OnChip SATA Channel OnChip SATA Channel
OnChip SATA Type OnChip SATA Type
SATA IDE Combined Mode SATA IDE Combined Mode
Combined Mode Option
↑↓←→:Move
► OnBoard PCI IDE Controller
[Disabled]: Disable the integrated IDE controller.
[Primary]: Enable only the Primary IDE controller.
[Secondary]: Enable only the Secondary IDE controller.
[Both]: Enable both IDE controllers.
► OnChip SATA Channel
[Disabled] : Disable SATA ports 1,2,3,4.
[Enabled] : Enable SATA ports 1,2,3,4.
► OnChip SATA Type
This item is used to set the operating mode of your SATA ports.
Options : [Native IDE]; [RAID]; [AHCI]; [Legacy IDE].
[Native IDE] - This configures the SATA ports to support native IDE mode.
[RAID] - When you enable RAID, it means all your SATA drives must also support AHCI.
[AHCI] - The Advanced Host Controller Interface (AHCI) specification describes the register
level interface for a Host Controller for Serial ATA. The specification includes a description of
the hardware/software interface between system software and the host controller hardware.
AHCI provides more advanced features including SATA features, but some SATA drives may
not support AHCI, unless they are labeled with AHCI support in its specification.
If your motherboard supporting AHCI, and you have a SATA device, which also supports AHCI,
then you can select IDE option to have fair performance (only PATA, SATA level), or you can
select AHCI to get its best performance.
[Legacy IDE] - This configures the SATA ports to support legacy IDE mode which is running
for old Windows system.
► SATA IDE Combined Mode
[Disabled] : Disable SATA ports 5, 6.
[Enabled] : SATA ports 5, 6 are used to simulate two additional IDE ports. You can select from
PATA or SATA as the Primary IDE through the next "Combined Mode Option" setting. Four
drives are displayed as IDE Channel 0 Master/Slave and IDE Channel 1 Master/Slave in
"System Information" menu.
IDE Configuration
[Both] [Both]
[Enabled] [Enabled]
[Native IDE] [Native IDE]
[Enabled] [Enabled]
[SATA as Primary]
Enter:Select
F1:General Help
ports 1,2,3,4. .
Disabled: Disable the
I integrated IDE I integrated IDE
controller. controller.
Primary: Enable only Primary: Enable only
the Primary IDE the Primary IDE
controller.
Secondary: Enable
only the Secondary IDE
controller.
Both: Enable both IDE
controllers.
+/-/:Value F10:Save
F9:Optimized Defaults
35
Help Item
ESC:Exit