Superio Configuration; Onboard Floppy Controller - Foxconn A76ML Series User Manual

DOS mode. The available settings are: [High Speed] in 480Mbps; [Full Speed] in 12Mbps.
► Legacy USB Support
This item is used to enable the support for USB devices on legacy OS. If you have a USB
keyboard or mouse, set to auto or enabled.
If USB devices are connected to the computer, the following item will appear:
► USB Storage Configuration
After pressing <Enter>, you can set the reset delay for the USB mass storage device. There
are many different emulation types of this USB device, such as floppy, hard disk and CDROM
can be selected.

SuperIO Configuration

SuperIO Configuration

OnBoard Floppy Controller

Serial Port1 Address
IR Address
IR Mode
IR Duplex Mode
Parallel Port Address
Parallel Port Mode
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► IR Address
This item is used to assign the I/O address and interrupt request (IRQ) for the IR port.
► IR Mode
This item is used to set the IR mode. The available settings are :
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASK IR] : A faster IrDA for 1152000 bit/s.
► IR Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
► Parallel Port Address
This item is used to assign the I/O address for the onboard parallel port .
► Parallel Port Mode
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
SuperIO Configuration
↑↓←→:Move Enter:Select
F1:General Help
[Enabled] [Enabled] Allows BIOS to enable
[3F8/IRQ4] or disable floppy
[2F8/IRQ3] controller.
[IrDA]
[Half Duplex]
[378]
[Normal]
+/-/:Value F10:Save
F9:Optimized Defaults
36
Help Item
ESC:Exit