Setting Up A Non-Bootable Raid Array - Foxconn A76ML Series User Manual

5-5 Setting Up a Non-Bootable RAID Array

This section assumes the following setup :
■ Boot Disk with Windows XP installed :
One hard disk HDS728090PLAT20 (80GB) is connected to the IDE channel, and set
to Master.
■ A Mirrored RAID Array Disk :
Two SATA hard disks are configured as a mirrored RAID1 array, they are :
Hitachi HDT725025VLA3, (250.05GB) connected to SATA port2 of the motherboard.
Seagate ST3320620AS, (320.07GB) connected to SATA port3.
■ A SATA DVD Drive :
A DVD drive connected to SATA port1.
To achieve the best performance and reliability, we highly recommend you
using the hard disks with the same brand, size and model number. Though
we are using different brand of hard disks as an example here, the purpose
is only for easy understanding.
1. Reboot your system, and go to "IDE Configuration" menu.
Enable the RAID function. Press [F10] to save the settings and reboot.
IDE Configuration
OnBoard PCI IDE Controller
OnChip SATA Channel
OnChip SATA Type
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
↑↓←→:Move Enter:Select
F1:General Help
IDE Configuration
[Enabled]
[Enabled] I
[RAID]
[RAID] Native IDE
RAID
AHCI
Legacy IDE
+/-/:Value F10:Save
F9:Optimized Defaults
93
Help Item
Options
ESC:Exit