Pantech Jest User Manual page 53

RESTRICTIONS
Use the following procedure to configure Location Setting, Calls and Messages
restrictions.
1. Slide the phone up, press the
7. Phone Settings, 7. Security.
2. Enter the four-digit lock code. The default lock code is the last 4 digits of your
phone number.
3. Press 2. Restrictions.
4. Enter the four-digit lock code again.
5. Select one of the following settings:
• Location Setting: Unlock Setting/Lock Setting.
• Calls: Incoming Calls/Outgoing Calls.
For Incoming Calls, set Allow
For Outgoing Calls, set Allow
• Messages: Incoming Messages/Outgoing Messages.
For Incoming Messages, set Allow All
For Outgoing Messages, set Allow All
6. Press the OK Key [SET].
PHONE LOCK SETTING
This setting specifies whether the phone should be locked whenever it is turned on.
Lock Mode prevents the unauthorized use of your phone. Once the phone is locked,
it is in restricted mode until the lock code is entered. You can still make emergency
calls.
1. Slide the phone up, press the
7. Phone Settings, 7. Security.
2. Enter the four-digit lock code. The default lock code is the last 4 digits of your
phone number.
3. Press 3. Phone Lock Setting.
4. Select one of the following settings, then press the OK Key [SET].
102
[MENU], then press 9. Settings &
All, Contacts Only or Block All.
All, Contacts Only or Block All.
or Block All.
or Block All.
[MENU], then press 9. Settings &
• Unlocked:
• On Power Up:
LOCK PHONE NOW
Tools,
Lock the phone now.
1. Slide the phone up, press the
7. Phone
2. Enter the four-digit lock code. The default lock code is the last 4 digits of your
phone number.
3. Press 4. Lock Phone
4. To unlock the phone from idle mode, slide the phone up, then press the
Right Soft Key
RESTORE PHONE
To delete all User Data and restore all settings to their initial defaults:
1. Slide the phone up, press the
7. Phone
2. Enter the four-digit lock code.
3. Press 5. Restore
4. A confirmation message appears in the display, select Yes, and then press
the OK Key.
5. After reading the message that appears, press the OK Key.
6. Enter the four-digit lock code. The phone will turn off and then back on
again automatically.
Tools,
SYSTEM SELECT
You can set your phone to search or roam on another network when you are not in your
home area. Leave this setting as default unless you want to alter the system selection as
instructed by your service provider.
1. Slide the phone up, press the
7. Phone
Phone is unlocked.
Phone will lock when it is turned on.
[MENU], then press
Settings, 7. Security.
Now.
[Unlock] and enter the four-digit lock code.
[MENU], then press
Settings, 7. Security.
Phone.
[MENU], then press
Settings, 8. System Select.
01
9. Settings & Tools,
02
03
04
05
06
07
9. Settings & Tools,
9. Settings & Tools,
103