Pantech Jest User Manual page 37

2. Press the Right Soft Key
Shortcut: From idle mode, press and hold the CLR Key
Commands menu and press the Right Soft Key
3. Select Automatic, Always Confirm
Key [SET].
SENSITIVITY
The Sensitivity setting allows you to adjust the sensitivity monitoring of voice tones.
If you frequently experience the messages
NOT RECOGNIZED Try again?", adjust the sensitivity toward
frequently experience false activations (when the phone recognizes a name you
didn't say), adjust the sensitivity toward
1. Slide the phone up, press the
3. Tools, 1. Voice Commands.
2. Press the Right Soft Key
3. Select More Sensitive, Automatic
Key [SET].
ADAPT VOICE
Voice Commands are speaker independent, which means that no training
or adaptation is required. Some users with heavy accents or unusual voice
characteristics may find difficulty in achieving high accuracy with speaker
independent Voice Commands, so the Adapt Voice feature allows users to
dramatically improve the recognition accuracy after adapting their voices. Users who
get acceptable recognition accuracy will find no additional benefit to performing the
Adapt Voice feature.
1. Slide the phone up, press the
3. Tools, 1. Voice Commands.
2. Press the Right Soft Key
3. Select 1. Train Voice or 2. Reset
70
[Settings] and then press 1. Confirm Choices.
to access the Voice
[Settings].
or Never Confirm, then press the OK
"Please try again" or "COMMAND
Less Sensitive. If you
More Sensitive.
[MENU], then press 9. Settings &
[Settings] and then press 2. Sensitivity.
or Less Sensitive, then press the OK
[MENU], then press 9. Settings &
[Settings] and then press 3. Adapt Voice.
Voice, then press the OK Key.
• Train Voice:
• Reset Voice:
4. "Adaptation will take a couple of minutes to complete. Adapt in a
quiet room. Press OK to
Key. Wait for the beep, and then repeat the sentences using a normal tone
of voice.
5. When you are finished with a full session, you will reach a screen that reads
"Adaptation
PROMPTS
Tools,
Allows you to select voice command system characteristics.
1. Slide the phone up, press the
3. Tools,
2. Press the Right Soft Key
3. Select 1.
• Mode: Select the voice command system mode from the following:
- Prompts:
- Readout+Alerts:
- Readout:
- Tones Only:
• Audio playback:
• Timeout:
Tools,
4. Select an option and press the OK Key [SET].
Requires that you make recordings of your voice to customize the voice
recognition system. It will take a few minutes.
Once you finish the adaptation process, you can reset the adaptation to
the factory default. The Reset Voice option only appears after you finish
the Train Voice process.
begin." will appear on the screen. Press the OK
Complete".
[MENU], then press
1. Voice Commands.
[Settings] and then press
Mode, 2. Audio playback or 3. Timeout, then press the OK Key.
For handset to prompt for required information.
For handset to prompt for required information and readout the
contents of the screen and phone alerts.
For handset to prompt for required information and readout the contents
of the screen.
For handset to provide beeps only for audio guidance.
Allows audio playback to play through the speakerphone or earpiece.
Select Automatic, Speakerphone or Earpiece.
Select a period of time either 5 seconds or 10 seconds
listens for a command before timing out.
01
02
03
04
05
06
07
9. Settings & Tools,
4. Prompts.
which the system
71