Jeep Wrangler 2013 User Manual page 74

ELECTRONICS
Phone Pairing
NOTE:
• Pairing is a one-time initial setup before using the phone.
• Prior to starting the pairing procedure ensure all additional phones within the
vehicle have their Bluetooth
• The Uconnect™ Phone requires a mobile phone equipped with the Bluetooth
Hands-Free Profile, Version 1.0 or higher. For Uconnect™ customer support, call
1–877–855–8400 or visit www.UconnectPhone.com. This site will provide spe-
cific instructions based on the type of mobile phone being paired.
NOTE:
Pairing is a one-time initial setup before using the phone.
• Press the "Phone"
• Wait for the "ready" prompt and BEEP.
• (After the BEEP), say "setup" or "Uconnect device setup".
• (After the BEEP), say "device pairing".
• (After the BEEP), say "pair a device".
• Follow the audible prompts.
• You will be asked to say a four-digit
Personal Identification Number (PIN),
which you will later need to enter into
your mobile phone. You can say any
four-digit PIN. You will not need to
remember this PIN after the initial
pairing process.
• You will then be prompted to give the phone pairing a name (each phone paired
should have a unique name).
• Next you will be asked to give this new pairing a priority of 1 thru 7 (up to seven
phones may be paired); 1 is the highest and 7 is the lowest priority. The system will
only connect to the highest priority phone that exists within the proximity of the
vehicle.
• You will then need to start the pairing procedure on your cell phone. Follow the
Bluetooth ® instructions in your cell phone Owner's Manual to complete the phone
pairing setup.
72
® disabled.
button to begin.
®