Single Delegate; Chairman - Bosch DCN-DS Installation And Operation Manual

DCN-D Conference Delegate Units
1.
2.
3.
4.
5.
7.4.1

Single delegate

Default, the delegate unit comes in the single delegate mode and has the default microphone
button installed. Refer to Table 7.3.
Figure 7.4 Default microphone button
7.4.2

Chairman

When the delegate unit is in the chairman mode, it is a chairman device for 1 chairman (refer
to Table 7.3). You can put all types of delegate units in the chairman mode. When you put the
delegate unit in the chairman mode, you also have to install the DCN-DBCM buttons (to be
ordered separately). Refer also to Section 5 Installation.
Figure 7.5 DCN-DBCM microphone buttons
The functional difference between a delegate unit and a chairman unit is the priority button
on the left hand side of the microphone button. With the priority button, the chairman can
disable the microphones of all delegate units used in the DCN system. At the same time, the
priority button enables the microphone of the chairman.
The delegate unit in chairman mode has the possibility to:
–
–
NOTICE!
The DCN-DBCM button set comes with a tool that you can use to remove the buttons from the
delegate unit. Refer to Section 5 Installation.
Bosch Security Systems B.V.
Disconnect the delegate unit from the DCN system.
Change the mode of the delegate unit (refer to Table 7.3).
Change the button, if required refer to Section 5 Installation.
Re-connect the delegate unit to the DCN system.
If required, (de-)initialize the delegate unit (refer to Section 7.1 Initialization).
Play an attention chime when the chairman pushes the priority button.
Erase the request-to-speak list and the speakers list when the chairman pushes the
priority button.
Installation and Operation manual
Configuration | en 19
F.01U.265.631 | V1.0 | 2012.03