Single Delegate With Auxiliary Control - Bosch DCN-DS Installation And Operation Manual

20 en | Configuration
7.4.3

Single delegate with auxiliary control

When the delegate unit is in the single delegate with auxiliary control mode, it is a delegate
device for 1 delegate (refer to Table 7.3). The delegate can use the left hand side microphone
button as an auxiliary button. For example, to activate an indicator.
NOTICE!
When the delegate pushes the auxiliary button, the auxiliary button makes an event. Use the
DCN Open Interface to program the actions that must be started by the event. Refer to the
applicable DCN software user manual for instructions that tell you how to program the Open
Interface.
The following types of delegate units can be used in the single delegate with auxiliary control
mode:
–
–
When you put the delegate unit in the single delegate with auxiliary control mode, you have to
install two microphone buttons. For example, you can use the DCN-DBCM buttons (to be
ordered separately). Refer also to Section 5 Installation.
CAUTION!
The DCN-DS/L and DCN-DCS delegate units do not support the single delegate with auxiliary
control mode. When this mode is set, the delegate unit will be operate as single user.
F.01U.265.631 | V1.0 | 2012.03
DCN-DV
DCN-DVCS
Installation and Operation manual
DCN-D Conference Delegate Units
Bosch Security Systems B.V.