Zūmo Troubleshooting - Garmin zumo 500 Owner's Manual

a
PPendiX
zūmo Troubleshooting
Problem/Question
The zūmo does not
acquire satellite
signals.
How do I clear all my
user data?
The zūmo is locked
up/frozen.
The suction cup will not
stay on my windshield.
My battery gauge does
not seem accurate.
The touch screen is not
responding to my taps
properly.
My Bluetooth device
will not connect to the
zūmo.
62
Autogood products internet store http://130.com.ua
It can take a few minutes to acquire satellite signals. Go to an
open area, out of garages, and away from tall buildings. Stop
your vehicle, and position the zūmo where there is a clear
view of the sky. The bars in the upper-left corner
satellite strength.
Hold your finger on the lower-right corner of the zūmo's screen
while turning on the zūmo. Keep your finger pressed until the
message appears. Touch
To reset your zūmo, press and hold
Clean the suction cup and windshield. Dry with a clean, dry
cloth. Mount the suction cup as described on
Allow the unit to fully discharge, and then fully charge it (without
interrupting the charge cycle).
Calibrate the touch screen. Turn the unit off. Press and hold
for about one minute until the Calibration page appears. Follow
the on-screen instructions.
Verify that the Bluetooth field is set to Enabled. Make sure your
Bluetooth device is turned on and is less than 10 meters (about
33 feet) away from your zūmo. Go to
for a list of compatible phones and headsets.
Solution/Answer
Yes to clear all user data.
and press
www.garmin.com/bluetooth
zūmo 500/550 Owner's Manual
indicate
.
page 50.