Positioner Setting; Service Search - Xcruiser XDSR385HD User Manual

3.2 Positioner Setting

w w
Satellite: Select the satellite
which you want to search for
the Service.
- Press the LEFT/RIGHT ARROW
button to select the satellite.
- If you press the OK button, a
complete satellite list will be
displayed.
- Select the wanted satellite
name.
- If desired satellite name is not
w w listed then select User Deined.
Frequency: Select the satellite
frequency you want to use to
w w check for a signal.
Positioner: Select the
positioner.
- None: (No Positioner)
- Using DiSEqC 1.2:
Move: To move the dish, press
LEFT/RIGHT button.
Fine Move: To move the dish in
smaller steps, press the LEFT/
RIGHT ARROW button.
Step: Set to positioner moving
steps as 1, 2, 3, 4
Positioner Command: To use
various positioner commands,
press the OK button.
Then, available positioner
commands will appear.
- Using USALS:
Dish Longitude: Enter the
longitude position of the
antenna using the NUMERIC
buttons.
41
Dish Latitude: Enter the latitude
using the NUMERIC buttons.
Go To: Press the OK button to
rotate the dish to the selected
antenna position.
Positioner Command: To use
various positioner commands,
press the OK button.
Then, available positioner
commands will appear.
- Dish Setting: Press the OK
button to move to Dish Setting
menu directly.
- Service Search: Press the OK
button to move to Service Search
menu directly.
XDSR385HD

3.3 Service Search

w w
Auto Search Mode:
- Satellite: Press the OK button to
select the target satellite to be
searched.
- Search Type: Select the search
type.
- Network Search: You can select
Of or On. When you select
'On' , you can ind more
transponders using the home
network. As it refers to NIT
during searching, if there is
the frequency information of
other transponder, it searches
the other transponder besides
the transponder that the user
inputs.