Table of Contents
Advertisement
M5 standard/security screws
C. Screws and screw anchors for fixing the standard pendent mount onto the wall
(not included)
Tools needed
Tool for drilling
Tool for screwing
To pendant mount the dome camera
1. Drill a cable-access hole in the wall where you want to install the pendant mount.
2. Using the correct screws and screw anchors, fix the pendant mount to the wall.
Figure 10: Pendant-mount
Standard pendant mount
1.
Pendant-mount
2.
Waterproof rubber boot
3.
Cover of the outdoor mounting kit
4.
22-pin connector is at the end of the I/O interface
cable
3. Attach the waterproof rubber boot to the pendant mount.
4. Run the cable through the pendant mount. The 22-pin connector of the I/O
interface cable should exit from the pendant mount.
Note:
Block the cable-entry hole in the wall with the supplied sponges to prevent
insects from entering the pendant mount.
5. Thread the cables through outdoor mount kit.
TruVision Mini PTZ 12X Camera User Manual
Extended pendant mount
5.
Screws and screw anchors to attach pendant mount
to wall
6.
Screws and washers to attach pendant mount to the
outdoor mounting kit
1BChapter 2: Installation
19
Advertisement
Table of Contents
