Installation Instructions; Location - Hayward Easy Temp Owner's Manual

Installation Instructions

Location

The placement of the pool heater is very important in keeping installation
costs to a minimum while providing for maximum effi ciency of operation, as
well as allowing adequate access for service and maintenance.
The pool heat pump is designed for outdoor installation and should
not be installed in a fully enclosed area, such as a shed, garage, etc.
Recirculation of cold discharged air back into the evaporator coil will greatly
reduce unit heating capacity and effi ciency.
The unit should be located as close as practical to the existing pool pump and
fi lter to minimize water piping. However, do not forget to provide a 24"clea-
rance at the very least all around your heat pump. The use of 90 degree bends
and short radius elbows in the water piping should be kept to a minimum.
Mount the unit on a sturdy base, preferably a concrete slab or a set of blocks.
The base should be completely isolated from the building foundation wall to
prevent the possibility of sound or vibration transmission into the building.
The size of the base should not be less than 36" x 36" (92 cm x 92 cm).
?
IMPORTANT
Air is pulled through the evaporator coil and
discharged through the top grille. A minimum
clearance of 72 inches should be allowed above
the unit for unrestricted air discharge. The unit
must not be installed under a porch. Any side of
the unit should be located at least 24 inches from a
72"
24"
wall or from any other obstruction for unrestricted
air intake and service access.
24"
24"
Service access
24" to 36"
6
OWNER'S MANUAL