Casio IT-800 Series User Manual page 52

1 USB Client Port
2 USB Host Port
3 Selector Switch
4 AC Adaptor Jack
5 Terminal Detect
Switch
6 Power/Signal
Terminals
7 Power Indicator
LED
8 Mount Hooks
Important!
Always make sure to fi rst remove the Handheld Terminal from the USB Cradle
when switching the selector switch.
Allowing the power contacts become wet can cause an electric shock or fi re. In
addition, if the contacts become soiled, contact may be impaired resulting in
poor charging. For reasons of safety and maintaining charging battery pack(s)
in optimum condition, clean the power contacts by wiping with a dry cloth or
cotton swab after disconnecting the AC adaptor.
Never short out the power contacts of the USB Cradle. This can damage the
USB Cradle.
Do not subject the Handheld Terminal and USB Cradle to vibration or impact
during communication. This can cause communication to be interrupted.
When placing the IT-800 into the cradle, make sure that it is seated properly and
that the power LED at the front of the USB Cradle is lit in green. Charging and
communication will not proceed properly if the Handheld Terminal is not seated
properly.
Always cap ports that are not being used. Using the USB Cradle while the ports
are uncapped can cause damage.
E-50
This port is used to transmit system data and fi le data (download,
upload) by connecting the Cradle to a PC using a USB cable
(DT-380USB). A dedicated driver must be installed in the PC
before connecting the Cradle to the PC.
This port is used to connect a corresponding USB peripheral
device.
This switch is used to switch between the USB host port and
USB client port. Set the switch to the "A" position when using
the unit as a USB host, or set it to the "B" position when using
the unit as a USB client.
Connect the AC adaptor (sold separately) here.
This switch detects when the IT-800 is seated correctly on the
Cradle.
Power is supplied to the IT-800 via these contacts. Also used for
data communication.
This LED indicates the power status and the mounting status of
the IT-800.
Off: IT-800 is not installed.
Green: Power on, IT-800 mounted correctly.
These hooks are used to stabilize the Handheld Terminal when
mounting it on the cradle.