Table of Contents
Advertisement
Getting Ready
Preparing the Remote Controllers
Load two AAA-size alkaline batteries into each of the remote controllers: one YT-200 Control Box remote
controller, one YT-120 projector remote controller. Batteries are provided with the Projector System.
To load batteries: Open the battery cover on the back of a remote controller. Load the batteries making
sure their poles (+/–) are facing in the correct directions. Finally, replace the battery cover.
Important!
Important!
Important!
To avoid running down the battery, store the remote control unit so its keys are not pressed
inadvertently.
When batteries go dead, remove them as soon as possible and replace them with two new
AAA-size alkaline batteries.
Configuring the Initial Settings of the Two Projectors
The initial settings of each projector need to be configured individually.
Perform the procedure below after placing the Projector System in the location where it will be used,
after connecting cables, and after preparing the remote controllers.
For information about which projector is Projector A and which one is Projector B, see "Wiring" (page
E-7).
Perform the operations below using the projector remote controller (YT-120). Note that these
operations cannot be performed using the Control Box remote controller (YT-200).
To configuring the initial settings of the two projectors
1.
Unplug the power cord of Projector B from the power outlet so only Projector A is
plugged in.
2.
Remove the Projector A lens cover.
3.
On the remote controller, press the [P] (Power) key to turn on Projector A.
4.
After projection starts, use the Projector A focus ring to focus the projected image.
5.
On the "Language" screen that appears, select the display language you want to
use.
6.
On the remote controller, press the [INPUT] key. On the "Input" dialog box that
appears, select "HDMI" and then press the [ENTER] key.
E-8
Advertisement
Table of Contents
