Table of Contents
Advertisement
7.
On the remote controller, press the [MENU] key to display the setup menu, and then
configure the settings below in the indicated sequence.
(1) Option Settings 1 3 Auto Keystone Correction
(2) Screen Settings 3 Keystone Correction
(3) Screen Settings 3 No Signal Screen
(4) Input Settings 3 Signal Name Indicator
(5) Option Settings 1 3 Auto Power Off
If the Projector System will be used in an inverted ceiling mount configuration, select "On" for the
"Screen Settings 3 Ceiling Mount" setting.
If the Projector System will be used in a rear projection (projecting from behind the screen)
configuration, select "Rear" for the "Screen Settings 3 Projection Mode" setting.
If the Projector System will be used in a location at an elevation of 1,500 to 2,000 meters, select
"On" for the "Option Settings 2 3 High Altitude" setting.
8.
Press the [P] (Power) key twice to turn off Projector A.
9.
Unplug the power cord of Projector A from the power outlet and plug in Projector B.
10.
Repeat the above steps 2 through 8 on Projector B.
11.
Plug the power cord of Projector A into the power outlet.
Setting Item
E-9
Getting Ready
Setting
Off
0
Black
Off
Off
Advertisement
Table of Contents
