Changing The Needle; Changing The Presser Foot - Husqvarna Viking Scandinavia 200 User Manual

Learn your Scandinavia 200

Changing the Needle

!
Turn off the main switch.
Loosen the screw in the needle
1
clamp with the screwdriver.
Remove the needle.
2
Push the new needle upwards with
3
the fl at side away from you until it
will go no further.
Use the screwdriver to tighten the
4
screw properly.

Changing the Presser Foot

!
Turn off the main switch.
Make sure that the needle is in the
1
highest position. Pull the presser
foot towards you.
Line up the cross pin on the foot
2
with the gap in the presser foot
ankle. Press back until the foot
snaps into place.
Presser Foot Pressure (a)
The presser foot pressure is adjusted
with the dial found under the lid on
your Scandinavia 200. Normal setting
is around four. The higher the number
the more pressure the foot puts on the
fabric. Knit and soft fabrics should be
sewn at lower pressure.
Presser Foot Lever (b)
The presser foot is raised and lowered
with the presser foot lever. The presser
foot must be lowered when sewing.
By raising the presser foot lever and
then press it upwards, the lift height of
the presser foot can be raised to extra
height in order to slide thick projects
under the foot.
12
Always use needles of system 130/
705H.
1
a
2
b