Lexicon MC-12 Upgrade Instructions page 7

MC-12
10. Find the cable connected to location J15 on the XLR
board, which is located inside the MC-12 Balanced
chassis. Then, position the chassis upside down
above the MC-12 as shown in the illustration above,
aligning the loose end of the cable with the access
panel on the unit.
11. Slowly lower the chassis toward the unit, feeding the
loose end of the cable through the access panel. Do
this until the chassis is sitting on the unit, as shown
in the illustration at the right.
MC-12 to MC-12 Balanced Upgrade Instructions
12. Next, attach the MC-12 Balanced chassis to the
MC-12 using the four 4x10mm screws provided in
the upgrade kit. These screws enter the chassis at the
points identified in the illustration below. It is
recommended to use a screwdriver with a magnetic
tip to tighten these screws.
13. Once the screws have been tightened, cover them
with the 3/8 inch black hole plugs provided in the
upgrade kit.
7