Notes on continuous flash shooting
To prevent the SB-900 from overheating, allow the SB-900 to cool down for at least
10 minutes after the maximum number of continuous firings have been performed
as shown in the table below.
•
Setting the "Thermal Cut-out" function is recommended. (kF-6)
"
Do not exceed the maximum number of continuous firings,
as this may cause the flash head to overheat and can result in
CAUTION
burns and damage to the flash panel and body.
Maximum number of continuous fi rings
•
i-TTL
•
Non-TTL auto
•
Manual flash mode (flash output level: M1/1, M1/2
•
Manual flash mode (flash output level: M1/4 to M1/128)
"
Be careful when replacing batteries after continuous flash
use, because batteries may generate heat during continuous flash
CAUTION
photography.
Flash mode
Max. number of continuous
fi rings (at 6 frames/sec.)
15 or less
)
40 or less
F
F–5