Notes On Continuous Flash Shooting - Nikon SB-600 Instruction Manual

Notes on continuous flash shooting

WARNING
Max. number of continuous firings
Flash mode
TTL auto flash
Manual flash (Flash output level: M1/1, M1/2)
Manual flash (Flash output level: M1/4 to M1/64)
●●●
Synchronization during continuous flash shooting
The table below shows the maximum number of frames that can be taken
during continuous flash shooting. If the number of continuous frames shot
exceeds the value shown in the table, allow the SB-600 to cool off for at least
10 minutes.
Maximum number of frames during continuous flash shooting
(at six frames per sec.)
Batteries
Alkaline-manganese
Lithium
Nickel
NiCd
Ni-MH
38
Do not exceed the maximum number of continuous firings
You should allow the SB-600 to cool off for at least 10 minutes after the
maximum number of continuous firings are performed as shown in the
table below:
1/8
Up to 4
Max. number of continuous
firings (at 6 frames/sec.)
Flash output level
1/16 1/32
Up to 8 Up to 16
15
40
1/64
Up to 30