Operation - Ariens Razor Push Manual

CONTROLS AND FEATURES
See Figure 6 for locations.
WARNING: Improper operation
can lead to injury. Learn what the
controls do and how they work.
Thoroughly read and understand
entire Operator Manual.
CAUTION: AVOID INJURY. Read
and understand the entire
section before proceeding.
Engine/Blade Control Handle
(Figure 7)
CAUTION: Check function of
Engine/Blade Control Handle
regularly. Improper function of
control could cause injury.
The engine/blade control handle must be
held against the handlebar to start the engine
and blade.
IMPORTANT: The Engine/Blade Control
feature stops engine and blade within 3
seconds of operator releasing handlebar.
Check this feature frequently. If feature fails
to operate, disconnect spark plug wire and
adjust or have it repaired before using unit.
STOP
Figure 7
Handlebar
Adjust handlebar to a safe and comfortable
height. See HANDLEBAR HEIGHT on
page 20.
Recoil Starter Handle
When pulled, handle will turn engine over.

OPERATION

Safety
START and RUN
CUTTING HEIGHT ADJUSTMENT
DANGER: Avoid injury from
rotating blade.
ALWAYS shut off engine before
adjusting cutting height.
Cutting Height Settings Chart
Notch
1
2
3
4
5
6
7
To change cutting height, move cutting height
levers one notch at a time to set desired
height (Figure 8).
1
2
1. Cutting Height Lever
2. Lowest Position
3. Highest Position
EN - 13
Cut grass length
1" (25 mm)
1-1/2" (38 mm)
2" (51 mm)
2-1/2" (64 mm)
3" (76 mm)
3-1/2" (89 mm)
4" (102 mm)
3
Figure 8