CONTROLS AND FEATURES ENGLISH 1. Throttle/Choke Control 2. Mower Clutch Lever 3. Parking Brake 4. Clutch Pedal 5. Brake Pedal 6. Mower Height Lever 7. Ignition Key Switch 8. Speed Indicator WARNING 9. Roller 10. Mower Pan Depress clutch pedal and push latch to set.
Ariens authorized replacement part may adversely affect the performance, durability, or safety of this unit When ordering replacement parts and may void the warranty. Ariens disclaims liability for Transfer or making service inquiries, know any claims or damages, whether warranty, property model &...
5. Review Limited Warranty Policy. 6. Fill out Original Purchaser Registration Card and 2. Understand all Safety Precautions provided in the return the card to Ariens Company. manuals. 3. Review control functions and operation of the unit. Do not operate unit unless all controls function as described in this manual.
Keep children and others away from unit while Do not operate mower unless guards are in operating. operating position or bagger is attached. OL4140 OL3320 Stop engine and remove ignition key before ASSEMBLY SAFETY RULES servicing or leaving operator’s position for Read, understand, and follow all safety practices in any reason.
Page 6
Wear adequate safety gear and protective gloves. DO NOT operate at too fast a rate. DO NOT change Wear proper footwear to improve footing on slippery engine governor settings or over-speed engine. Slow surfaces. down before turning. DO NOT wear loose clothing or jewelry and tie back DO NOT mow near dropoffs, ditches or embankments.
Page 7
TOWING BATTERY SAFETY RULES Tow only with a machine that has a hitch designed for Avoid Electric Shock. Objects contacting both battery towing. Do not attach towed equipment except at the terminals at the same time may result in injury and unit hitch point.
Stop and inspect equipment if you strike an object. STORAGE SAFETY RULES Repair, if necessary, before restarting. Never make Never store the machine or fuel container inside a adjustments or repairs with the engine running. building where there is an open flame, such as a water Mower blades are sharp and can cut you.
Page 9
To start engine, Speed Selector must be in Air Cleaner neutral (N). Check air filter for dirt. Clean as required. See Service Ariens recommends starting forward travel and Adjustments Section. in first (1) or second (2) speed, then Engine Fuel shifting “on the go”...
STARTING AND SHUT OFF PARKING CAUTION: DO NOT attempt to start unit at CAUTION: MACHINE ROLL AWAY can this time. Read and understand entire manual cause injury or death. ALWAYS engage before starting unit. parking brake when leaving unit unattended. Stop engine, and remove key before cleaning Electric Start or servicing unit.
flow, causing a reduction in the discharge of grass clippings. SERVICE AND ADJUSTMENTS Ariens Dealers will provide any service or adjustments FILLING FUEL TANK which may be required to keep your unit operating at peak efficiency.
ENGINE 4. If low, add oil and bring up to the Full (F) mark. DO NOT over fill. Oil level must not exceed Full See Figure 4. For further information on the engines, (F) mark. refer to the enclosed Engine Manual. 5.
Page 13
4. Saturate with engine oil and squeeze (do not Mower Drive Belt Replacement twist) to distribute oil and remove excess oil. See Figures 6-7. Paper Filter 1. Remove rear belt finger from back cover and mower belt from engine pulley. Do not attempt to clean or oil filter.
MOWER BLADE 4. Remove cotter pin from clutch rod and rod from clutch link. 5. Remove hair pin and front hanger pin to CAUTION: Replace bent, worn or damaged disconnect front linkage. blades. 6. On 32" mower, remove hair pins and positioning See figure 8.
Place unit on a level surface, shut off engine and open battery compartment to gain access to battery. WARNING: EXPLOSIVE GASES from battery can cause death or serious injury. 1. Disconnect negative (–) cable first, then positive ALWAYS keep open flames, sparks, or (+) cable.
TIRES WARNING: UNIT MOVEMENT can result in NOTE: Keep tires properly inflated at all times. For death or serious injury. NEVER jump start unit proper tire inflation when working under various condi- directly to the starter or starter solenoid. Unit tions, refer to chart below.
Page 17
See Engine Manuals for further maintenance and trouble shooting information. ADJUSTMENTS MAINTENANCE SCHEDULE Ariens Company recommends that you have adjustments made by your Ariens dealer. They have Before Service Performed Each the knowledge and tools to properly perform adjustments which may be required to keep your equipment operating at peak efficiency.
Page 18
• Adjust double nuts on clutch rod until carrier yoke 2. Belt engagement should occur when front edge clears neutral stop by 1/8 to 1/4 inch (3–6 mm). of Mower Clutch is positioned in line with rear • Release Parking Brake and turn both rear wheels by edge of forward notch of quadrant (as viewed hand.
Page 19
1. Cutting Tip 4. Ground Level 2. Mower Pan 5. Cutting Height 1. Blade Cutting Edges 3. Blade 6. Discharge Chute Front of Unit 2. Ground Level 3. Front Blade Height Figure 15 4. Rear Blade Height OT0860 Figure 16 CAUTION: Rotate mower blade with Mower OT0130 Clutch disengaged (OUT) and take...
Touch up all areas to prevent rust. Inspect unit for visible signs of wear, breakage or Matching touch up paint is available from your Ariens damage. Order any parts required and make Dealer. Store mower in a cool, dry protected location.
TROUBLE SHOOTING SERVICE PARTS Problem Probable Cause Part No. Qty. Description 02749400 Battery Starter will not Shift lever in gear (no spark). operate when the PTO engaged. 07216900 PTO Belt (Engine to 28”, 30” ignition key is Defective solenoid switch. Decks) turned to the "S"...
Ariens Company warrants to the original purchaser that consumer products manufactured by Ariens Company will be free from defects in material and workmanship for a period of two (2) years after the date of purchase, and will repair any defect in material or...
Page 24
Ariens Company 655 West Ryan Street P.O. Box 157 Brillion, WI 54110-0157 920-756-2141 Fax 920-756-2407...