Installation; Installation Location; Your Refrigerator Needs Ventilation - Kuppersbusch IKE 188-4 Operating Instructions Manual

Table of Contents

Advertisement

Installation

Installation Location

The appliance should be set up in a well ventilated, dry
room.
Energy use and efficient performance of the appliance is
affected by the ambient temperature.
The appliance should therefore
– not be exposed to direct sunlight;
– not be installed next to radiators, cookers or other
sources of heat;
– only be installed at a location whose ambient tem-
perature corresponds to the climate classification,
for which the appliance is designed.
The climate classification can be found on the rating plate,
which is located at the left on the inside of the appliance.
The following table shows which ambient temperature is
correct for each climate classification:
If installation next to a source of heat is unavoidable, the fol-
lowing minimum clearances must be maintained at the
sides of the appliance:
– for electric cookers 3 cm;
– for oil and coal fired ranges 30 cm.
If these clearances cannot be maintained a heat insulating
pad is required between the cooker and the refrigeration
appliance.

Your Refrigerator needs Ventilation

The integrated door of the furniture cabinet largely seals the
installation recess. Appliances for integrating must there-
fore be provided with ventilation by having an opening in the
furniture plinth. The warmed air must be able to be
exhausted upwards through the air shaft on the furniture
back. The ventilation cross-sections should be at least 200
2
cm
.
Important note! In order not to impair the function of the
appliance, never cover or obstruct the ventilation openings.
Installation
See „Installation Instructions" supplied.
Please check whether, after installing your appliance and
especially after rehingeing the door, the door seal seals right
round. An untight door seal may lead to heavy frosting and
thereby to a higher power consumption (see also „What to
do if...").
20
If the refrigeration appliance is installed next to another
refrigerator or freezer a clearance of 5 cm at the sides is
required, in order to prevent the formation of condensation
on the outside of the appliance.
Climate
classification
SN
N
ST
T
min. 200 cm
for an ambient
temperature of
+10 to +32 °C
+16 to +32 °C
+18 to +38 °C
+18 to +43 °C
2
50
50
2
min. 200 cm

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ike 248-4

Table of Contents