Contents Safety information Care and cleaning Operation What to do if… First use Technical data Daily use Installation Helpful hints and tips Environmental concerns Subject to change without notice Safety information In the interest of your safety and to ensure will prevent it from becoming a death trap the correct use, before installing and first us- for a child.
Page 3
• It is dangerous to alter the specifications or pressure on the container, which may modify this product in any way. Any dam- cause it to explode, resulting in damage to age to the cord may cause a short-circuit, the appliance. fire and/or electric shock.
Service either its refrigerant circuit or insulation materials. The appliance shall not be dis- • Any electrical work required to do the serv- carded together with the urban refuse icing of the appliance should be carried out and rubbish. The insulation foam con- by a qualified electrician or competent per- tains flammable gases: the appliance son.
Page 5
Important! In this condition, the refrigerator compartment temperature might drop below 0°C. If this occurs reset the temperature regulator to a warmer setting. Storage of frozen food When first starting-up or after a period out of use, before putting the products in the com- partment let the appliance run at least 2 hours on the higher settings.
gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Helpful hints and tips Hints for energy saving Fruit and vegetables: these should be thor- oughly cleaned and placed in the special •...
• do not allow fresh, unfrozen food to touch • make sure that the commercially frozen food which is already frozen, thus avoiding foodstuffs were adequately stored by the a rise in temperature of the latter; retailer; • lean foods store better and longer than •...
5. Switch on the appliance. 6. Set the temperature regulator to obtain the maximum coldness and run the ap- pliance for two or three hours using this setting. 7. Reload the previously removed food into the compartment. Warning! Never use sharp metal tools to scrape off frost from the evaporator as you could damage it.
Page 9
Problem Possible cause Solution The appliance has no power. Connect a different electrical appli- There is no voltage in the mains ance to the mains socket. socket. Contact a qualified electrician. The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".
Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "In- stallation". 3. If necessary, replace the defective door gaskets. Contact the Service Force Cen- ter. Technical data Dimension of the recess Height 1030 mm Width 560 mm Depth...
Page 11
2. Remove the door. min. 3. Remove the spacer. 200 cm 4. With a key, loosen the lower pin. min. 200 cm Installing the appliance Caution! Make sure that the mains cable can move freely. On the opposite side: 1. Tighten the lower pin. Do the following steps: 2.
Page 12
between the appliance and the kitchen furniture is correct. Open the door. Put the lower hinge cover in position. 44mm 5. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in op- posite case.
Page 13
Put together the appliance door and the furniture door and mark the holes. 8 mm 8. Install the part (Ha) on the inner side of the kitchen furniture. 11. Remove the brackets and mark a dis- ca. 50 mm tance of 8 mm from the outer edge of the door where the nail must be fitted (K).
Page 14
Do a final check to make sure that: • All screws are tightened. • The magnetic sealing strip is attached tightly to the cabinet. Important! If the ambient temperature is low (for example, in the Winter), the size of the gasket decreases.
Reversibility of the freezer door 180˚ Environmental concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
Need help?
Do you have a question about the IKE187-9 and is the answer not in the manual?
Questions and answers