Setup Of Screensaver Time - Panasonic TH-42BT300W Operating Instructions Manual

Setup menu
3

Setup of Screensaver Time

After selecting Time Designation, Interval or Standby after SCR Saver, the relevant Time Setup will become
available for selection and the Operating Time may be set. (Time cannot be set when "Mode" is "On" or "Off".)
Screensaver
Start
Function Negative image
Mode Time Designation
Start Time
Finish Time
Screensaver
Start
Function Negative image
Mode Interval
Periodic Time 12:00
Operating Time
Screensaver
Start
Function Negative image
Mode Standby after SCR Saver
Screensaver duration
4
Start setting
Select "Start".
Screensaver
Start
Function Negative image
Mode
52
Time 15:00
6:15
Notes:
12:30
• Pressing " " or " " button once changes the Time 1 minute.
[However, switching occurs every 15 minutes when Periodic Time is selected.]
• Pressing " " or " " button continuously changes the Time by 15 minutes.
Time 15:00
• "Screensaver duration" of the "Standby after SCR Saver" can be set from
0:00 to 23:59. When this is set to "0:00", " Standby after SCR Saver" will
not be activated.
Note: Timer function will not work unless "Day/Time Setup" is set.
3:00
Time 15:00
6:15
Time 15:00
On
The menu screen will disappear and the Screensaver will be activated. To
stop the Screensaver under On, press the R button or any buttons on
the main unit.
Note: When the display is turned off, the Scrensaver will be deactivated.
change
2
select
1
set
2
select
1