Sdi Through - Panasonic TH-42BT300W Operating Instructions Manual

Setup menu
• Sync
This function operates only during input from PC IN terminal.
Setting RGB sync signal
Confi rm that the input is set to RGB input (this setting is valid only for RGB input signal).
Auto: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.
on G: Uses a synchronized signal on the Video G signal, which is input from the G connector.
VBS: Uses a synchronized signal of Composite Sync input, which is input from the HD connector.
Setting Component sync signal
Confi rm that the input is set to Component input (this setting is valid only for Component input signal).
Auto: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.
on Y: Uses a synchronized signal on the Video Y signal, which is input from the Y connector.
Note:
Signals input to COMPONENT/RGB IN terminals correspond to Sync on G or Sync on Y.

• SDI Through

Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).
Off On
On: Enables active through.
Off: Disables active through.
Note:
Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board
(TY-FB11DHD) is selected.
• FRAME CREATION
Automatically compensates the picture frame rate and removes juddering movements to make the images
smooth.
Off Mid Max
Note:
Depending on the contents, images may be noisy. To prevent the noise, change the setting.
• 3D Refresh Rate
Reduces juddering or fl icker of image due to lighting interference during 3D viewing.
100Hz 120Hz
Note:
This setting is disabled when "FRAME CREATION" is set to "Off".
• HDMI Range
Switches the dynamic range according to the input signal from HDMI terminal.
Video(16-235) Full(0-255)
Video(16-235): If the input signal is the video range, Example: HDMI terminal output for DVD player
Full(0-255): If the input signal is full range, Example: HDMI terminal output for personal computer
Auto: Switches the dynamic range automatically between "Video(16-235)" and "Full(0-255)" according to the input signal.
Note:
This function can be set only for HDMI signal input.
• SDI Signal Format
This menu is available only when selecting a slot that the Dual HD-SDI Terminal Board for 3D (TY-FB30DHD3D) is
installed and set the input signal format for the board.
Auto YCbCr(4:2:2) 10bit
YCbCr(4:2:2) 12bit
Auto: Automatically selects the signal format according to the input signal.
46
Auto
YCbCr(4:2:2) 10bit 60p/50p
YCbCr(4:4:4) 12bit RGB(4:4:4) 12bit
YCbCr(4:4:4) 10bit RGB(4:4:4) 10bit
XYZ(4:4:4) 12bit