Waveform Monitor - Panasonic TH-42BT300W Operating Instructions Manual

Waveform Monitor

The input signal from video equipment is displayed as waveforms so that the signal level can be checked.
Notes:
• This function is enabled when "Studio mode" in Options menu is set to "On".
• This function is disabled during 3D images.
• Applicable input signal; HDMI, DVI, SDI
3D Settings
Signal
Waveform Monitor
Marker settings
RGB/MONO settings
Network Setup
Screensaver
Extended life settings
Input label
Function Button Settings
On/Off Timer Setup
Day/Time Setup
Network Setup
Component/RGB－in select
RGB
External scaler mode Off
Power save Off
Display of the waveform monitor
1
Set "Waveform Monitor" to "On".
The waveform monitor can also be displayed using the FUNCTION button on the remote control (see page
63).
2
Exit the menu.
3
Press to switch the display mode.
Notes:
• The display mode and display position of the waveform
monitor are stored.
• The aspect is fi xed as "16:9" during the waveform
monitor display.
Full scan mode
The display position of the waveform monitor can be changed with the cursor button.
Single line scan mode
Scan line can be changed with the cursor button.
100%
50%
0%
4
Press to exit the waveform monitor.
The waveform monitor ends after 5 minute time-out or by setting "Waveform Monitor" to "Off".
access
2
select
1
Y
100%
50%
0%
Select the item and set.
Waveform Monitor
Waveform Monitor Off
On
Time out (5 min)
• Waveform Monitor
On: The waveform monitor is displayed.
Off: The waveform monitor is not displayed.
• Time out (5 min)
The waveform monitor display time-out is set.
On: The display of the waveform monitor disappears in
5 minutes.
Off: The waveform monitor display time-out does not occur.
Full scan (Y)
Full scan (R)
Full scan (G)
Full scan (B)
Operation guide
Mode Change
Monitor Position Exit
Scan line
Operation guide
Y
Scan Line Position
Setup menu
change
2
select
1
Single line scan (B)
Single line scan (G)
Single line scan (R)
Single line scan (Y)
Mode Change
Exit
47