Page 1
BEDIENUNGSANWEISUNG mit Montageanweisungen Instructions for use and installation instructions Instructions d’ utilisation et avis de montage Gebruiksaanwijzing en montagehandleiding Istruzioni di uso e di montaggio Instrucciones de uso y de montaje TKD/TKDEM 988.1...
Safety instructions Example of how to use the cooker hood and the stove in complete safety: A switch at the window prevents the cooker hood from being operated when For connections and functions the window is closed. Maintenance and repair work may only be carried out by an authorised technician in accordance with the applicable safety regulations.
Your appliance at a glance Remote control (optional accessory) The remote control serves for switching on and off the lighting and ventilation Venting slots (in re- and for changing the ventilation setting. All other functions of the hood must circulation mode) be activated or deactivated directly at the control panel.
Cleaning, care and maintenance Changing the activated charcoal filter (in recircu- lation mode) Caution! For repair work or cleaning the inside of the hood, switch off the household fuse or pull out the mains plug. The activted charcoal filter is only required in the recirculation mode. It must not be used in the extraction mode.
Cause Remedy It is not possible to switch Electronic component Pull out mains plug or TKD 988.1: off the cooker hood. is defective. switch off fuse. Hood body with extendable glass fume trap, motor housing and switching unit Reconnect or switch on Breakdown of the Chimney, recirculated air deflector, reduction piece (150-125 mm).
Electric connection Extraction mode with external motor TKDEM 988.1 In addition to the exhaust channel, the control line for the external motor must be guided through the exhaust hole. Since the external motor is powered via The hood is fitted with a normal mains plug and there should therefore be a the cooker hood, a socket outlet must also be available here.
Page 8
Marking the drill holes adjusting screws. – Mark the four holes for the locking screws. The hood body is hung into a wall hook and additionally fastened by means of four locking screws. – Take the hood body off from the wall again.
TKDEM 988.1 only – Extend the upper chimney upwards and screw tight to the chimney attachement with the – Guide the control cable of the screws (F). external motor through the exhaust hole. – Remove the cover of the switching and control unit. –...
Guideline for extraction paths diameter, the suction power can be considerably reduced. The motor may become loud and irregular. The crucial factor is the correct transition of the exhaust channel into the Use round pipes with a 150 mm diameter or rectangular extraction channels chimney: with a cross section of 90 x 220 mm.
Need help?
Do you have a question about the TKD and is the answer not in the manual?
Questions and answers