Ultra Start 1280 series Installation Manual page 3

PAGE 3
QUICK VIEW WIRE DIAGRAM
SYSTEM PROGRAMMING - Menu 1
OUTPUT TO ACTIVATE THE VEHICLES STARTER CIRCUIT
OUTPUT TO ACTIVATE
12VOLT/ 30 AMP MAIN POWER INPUT
12VOLT/ 30 AMP MAIN POWER INPUT
SELECTABLE OUTPUT* (DEFAULT 2ND IGN)
OUTPUT TO ACTIVATE
(+) SIREN OUTPUT / (-) HORN OUTPUT
(-) STARTER KILL/ ANTI-GRIND OUTPUT
SELECTABLE PARK LIGHT OUTPUT (DEFAULT POSITIVE)
SYSTEM GROUND INPUT
REARM OUTPUT (PULSE WITH LOCK & AFTER START)
DISARM OUTPUT (PULSE WITH UNLOCK & BEFORE START)
NEGATIVE SECOND START OUTPUT
AUXILIARY OUTPUT TO ACTIVATE TRUNK RELEASE
(-) 2ND ACCESSORY/ PROGRAMMABLE AUXILIARY 2 OUTPUT
AUXILIARY 1 OUTPUT/ PROGRAMMABLE OUTPUT.
BRAKE SWITCH INPUT (12VOLT WHEN BRAKE IS PRESSED)
PARK BRAKE INPUT (-) ("M" SERIES ONLY)
HOOD PIN SWITCH (GROUND WHEN HOOD IS OPENED)
TACH DETECTION INPUT (CONNECT TO COIL, INJECTOR...)
DIESEL WAIT TO START (+ OR - INPUT) PROGRAMMABLE
POSITIVE DOOR INPUT (+ WHEN DOOR OPENED)
NEGATIVE DOOR INPUT (- WHEN DOOR OPENED)
Status Led's
* The selectable output can be changed in the program mode to output as a 2nd Accessory or 2nd Start output.
Default output is second ignition. **This output does not change back to 2nd Ignition upon reset**
**Siren output on alarm models and horn honk output on starter models.
***A "M" series remote starter must be used when installing on a manual transmission vehicle. NEVER
INSTALL AN AUTOMATIC REMOTE START IN A MANUAL VEHICLE!!
**** The door pin connections are used on Manual Transmission and Alarm Models Only.
THE DOOR DIN CONNECTION MUST BE CONNECTED FOR PASSIVE ARMING ON THE 1280 and 3285.
THE VEHICLES ACCESSORY CIRCUIT
THE VEHICLES IGNITION CIRCUIT
YELLOW
GREEN
RED
RED
WHITE*
BLUE
BROWN**
ORANGE
WHITE
BLACK
YELLOW
BROWN
GRAY
RED/WHITE
ORANGE/WHT
WHT/VIOLET
PINK
BLK/WHT***
GRN/WHITE
BLUE/WHITE
BLUE
PURPLE****
GREEN****
Program Button
80 SERIES
INSTALL MANUAL
1
2
3
4
5
6
1
2
3
4
1
2
3
4
5
6
7
8
9
10
11
12
13