Ultra Start 1280 series Installation Manual page 23

PAGE 23
PROGRAM MODE
SYSTEM PROGRAMMING - Menu 1
ENTERING PROGRAM MODE 4
IGNITION KEY
ON/OFF - ON/OFF - ON
(Leaving the key ON)
SETTING 1- TACH OPTIONS
THE SIREN WILL CHIRP 1 TIME WHEN SETTING 1 IS SELECTED
CHANGE SETTING 1 -
GOTO SETTING 2 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP
2 CHIRP
SETTING 2-ADJUST FOR UNDER-CRANK
THE SIREN WILL CHIRP 2 TIMES WHEN SETTING 2 IS SELECTED
CHANGE SETTING 2 -
GOTO SETTING 3 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP 1 CHIRP
SETTING 3-ADJUST FOR OVER-CRANK
THE SIREN WILL CHIRP 3 TIMES WHEN SETTING 3 IS SELECTED
CHANGE SETTING 3 -
GOTO SETTING 4 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP 1 CHIRP
SETTING 4- TACH WAIT
THE SIREN WILL CHIRP 4 TIMES WHEN SETTING 4 IS SELECTED
CHANGE SETTING 4 -
GOTO SETTING 1 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP 1 CHIRP
2 CHIRP 2 CHIRP
3 CHIRP 3 CHIRP
PROGRAM SWITCH
Press and release 1 time
PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
SETS OPTION 1 – HYBRID 1- The remote starter will ignore the Tach inpit after the
remote start activates.
SETS OPTION 2 –AUTO TACH LEARN- The system will automatically learns the
vehicles Tach. Tachless on TL Models. (DEFAULT)
PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
Each time the HORN/ SIREN chirps the Tach setting is reduced by 10%
PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
Each time the HORN/ SIREN chirps the Tach setting is increased by 10%
PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
SETS OPTION 1 – 300ms- The system will wait 300ms before starting to monitor the
Tach input.
SETS OPTION 2 – 750ms- The system will wait 750ms before starting to monitor the
Tach input.
SETS OPTION 3 – NO WAIT- The system will monitor the Tach as soon as the
vehicle has remote started. (DEFAULT)
SYSTEM PROGRAMMING - Menu 1
SIREN CHIRP
1 CHIRP
Confirming
Program Mode
PRESS
1 CHIRP
1 TIME
PRESS
2 CHIRP
1 TIME
PRESS
3 CHIRP
1 TIME
PRESS
4 CHIRP
1 TIME
80 SERIES
INSTALL MANUAL
REMOTE BUTTON
Press #
Button to
Select Menu 4
1X
2X
3X
4X