Table of Contents
Advertisement
REMOTE VEHICLE STARTER
14 Pin Connector - Continued From Previous Page
11-Blue/White
12-Blue
Glow Plug
13-White Park Lights
14-Black/ (-) Park Brake Input to detect Park Brake Switch. Connect to wire at
White
3 Pin Connector Red
1-Green
Door Lock
2-Red
12vlt Output
3-Blue
Door Unlock
4-Pink
2nd Unlock
* The centre pin of the keyless entry harness is not to be used for anything besides
plug-in devices such as the VP-1, DL-3, DL-7 and Data Bus Modules. Overloading this
output will damage the remote starter.
2 Pin Connector White
Black
Yellow
(-) Park Lights
4 Pin Connector Blue
RF Antenna/ Program Button Connector.
Remove the plastic from the adhesive tape and place the antenna in the center of the
windshield, behind the rear view mirror. Run the cable behind the head liner and A-pillar
panels to the module under the dash.
****The Antenna Must Be Connected Before the System will Operate.****
Tach
A/C Tach Signal Input. Used to detect when the vehicle has
started. This wire is connected to the vehicles coil, fuel injector
or crank sensor wire.
Diesel Glow plug input, detects both 12volt and negative
glow plug signals. Programmable input. See Menu 3
+10amp park light output. At light harness 0volts when
Park lights are off, 12volts when park lights are on.
the switch that switches to (-) when the switch is applied.
Door Lock Output - Programmable Menu 1 Setting 3.
Output For Door Lock Module Only!
Door Unlock Output - Programmable Menu 1 Setting 3.
Output when Unlock button is press twice. May be
programmed as Auxiliary output on button #5 (16xx)
(-) Horn
Output for horn activation
Output for activation of negative park light systems. May
be programmed as Auxiliary output on button #6 (16xx)
INSTALLATION MANUAL
Page 9
Advertisement
Table of Contents
