Table of Contents
Advertisement
REMOTE VEHICLE STARTER
1500/ 1600 Series- Side View
Temperature Sensor Input
Note: If the Temperature Sensor is installed the Cold Start Mode will operate
by monitoring temperate. If the sensor is not installed the Cold Start Mode
will function as Timer Mode. The temperature sensor can be installed under
the hood strapped to the radiator hose to monitor coolant temperature or left
mounted under the dash to monitor ambient air temperature.
Output on White wire
Second Starter
Second Accessory
Second Ignition
Jumper Selections
The jumpers control the output from the White wire on the 6- pin harness. This is a
30amp relayed output. To change the output of the wire access the jumpers by sliding
the plastic cover off the top of the case. Move the jumper to one of the following positions.
If the jumper is in position #1 the output on the white wire will be 2nd Starter
If the jumper is in position #2 the output on the white wire will be 2nd Accessory
If the jumper is in position #3 the output on the white wire will be 2nd Ignition*
Note: *The factory default setting of the selectable output jumper is position #3.
Jumper position
1 2 3
Position 1
Position 2
Position 3
INSTALLATION MANUAL
Not Available
Page 7
Jumpers
Advertisement
Table of Contents
