System Reset - Ultra Start 1155 Series Install Manual

Programming Overview
Program mode allows you to adjust the settings and options of your system.
Your system has been intelligently designed by installers with years of
experience. The system's default settings do not require any program changes
in most cases. However, this system does incorporate a highly advanced
programming system that can be easily adjusted.
Entering Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON - OFF - ON - OFF - ON. Leave in
the "ON" position.
3) Press and release the Program Button.
4) The park lights will come on and the horn (optional) will honk to confirm
Program Mode.
* Turning off the ignition or 30 seconds of no activity will exit the Program Mode.
This will be confirmed by 1 long horn honk and park light flash.
**: If the unit does not enter Program Mode, turn ignition off for 5 seconds and
repeat steps 1-4. **
The first ignition(Blue)MUST be connected to the vehicle's first ignition wire. If
it is not connected it will not be possible to enter the Program Modes.
Changing the Programmable Settings
1) Enter Program Mode. (See Above)
2) Press & release the Program Button the correct number of times to select
the desired Program Setting. The LED's will flash and the horn (optional) will
honk to indicate the current setting that is selected.
4) Hold the Program Button until the parking lights /horn confirm the selected
setting. The park lights will flash and the horn (optional) will honk to indicate the
option selected within the setting.
5) Turn the ignition key "Off" to exit Program Mode.

SYSTEM RESET

1) Within 3 seconds turn the key ON-OFF-ON-OFF-ON (Leaving Key ON).
2) Press and release the Program Button.
3) The park lights will turn ON and the horn(Optional) will honk once.
4) Press the Program Button a second time and hold for 8 seconds.
The park lights will flash and the horn (Optional) will honk 3 times.
The System is now re-set to the factory default settings.