Emc Class B Notices, Warnings, And Safety Information - Cisco Edge 340 Series Installation Manual

EMC Class B Notices, Warnings, and Safety Information

EMC Class B Notices, Warnings, and Safety Information
This section includes the EMC Class B warnings for the Cisco Edge 340 Series.
Statement 2018—Class B Notice for FCC
Modifying the equipment without Cisco's authorization may result in the equipment no longer
complying with FCC requirements for Class B digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any interference to
radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
•
•
•
The Part 15 radio device operates on a non-interference basis with other devices operating at this
Caution
frequency. Any changes or modification to said product not expressly approved by Cisco, including the
use of non-Cisco antennas, could void the user's authority to operate this device.
The band from 5600 to 5650 MHz will be disabled by the software during the manufacturing and cannot
Caution
be changed by the end user.
Within the 5.15 to 5.25 GHz band, this device is restricted to indoor operations to reduce any potential
Caution
for harmful interference to co-channel Mobile Satellite System (MSS) operations. This device meets all
the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.
Statement 2022—Class B Notice for Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Cisco Edge 340 Series Installation Guide
12
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio or TV technician for help.
OL-29523-01