Phase Adjust; Dip Switch Location - Bosch LTC 1271 Series Instruction Manual

5. CAMERA AND LENS SETTINGS
Camera module has various settings for any additional adjustments
that may be required. See figure 4 and 5 for adjustment locations.

5.1 Phase Adjust

The phase adjust control is located on the power board next to power cable
connections (see figure 4).To adjust phase, use a small screwdriver to rotate
control (blue block with yellow screw hole) until picture is synchronized with
other cameras in the system.

5.2 Dip Switch Location

See Detail B for dip switch information.
Figure 4 Camera Assembly
Figure 5 Dip Switch Location
9
Phase Adjust Pot on Power Board
Dip Switch Locations Dip Switch Locations
See Detail B for Switch Positions See Detail B for Switch Positions
.