Bosch LTC 1271 Series Instruction Manual page 8

4. Decide which conduit hole will be used and plug remaining openings using
the 2 plugs provided in the hardware kit.The conduit plug on top of the unit
may be secured by tightening the set screw at the back of the rear cover.
This must be done before the back cover is secured to the wall. Use a 2.5
mm Hex Key (not supplied).
5. Drill hole for conduit and run wiring.
6. Use 6 mm (1/4-inch) bolts with appropriate anchors for the type of wall
construction.
WARNING: THE CORNER PHORTRESS CAN WITHSTAND 300 LB OF STATIC
DOWNWARD LOAD IF APPROPRIATE BOLTS AND ANCHORS ARE
EMPLOYED.
7. Remove the camera module from packaging.
8. Loosen the nut located on the back plate approximately 6 turns without
removing, and insert camera bracket between the nut and retaining
bracket (see Figure 2).
9. Tighten nut securely.
10. Adjustability: Camera/lens is fully adjustable. See (Figure 3) for adjust-
ment points.
Forward/back adjustment;
use 10mm wrench.
Rotate adjustment dial;
Used to square camera
once adjustments have
been made.
Vertical adjustment; Phillips
screw & nut (two places)
11. Replace cover and secure using the supplied tamper-resistant screw (See
Figure 1).
Top Bracket
Install camera bracket
between top bracket and nut.
Figure 2 Rear Plate Exploded View
Figure 3 Camera Position Adjustment Points
Position camera as desired
and tighten fasteners securly.
Do not overtighten!
8
Nut; loosen but
do not remove.
Tilt adjustment;
Thumb nut
Entire base bracket rotates
for pan adjustment