Mounting Options; Wall Mounting Total Access 900E Series - ADTRAN Total Access 908e Hardware Installation Manual

Unit Installation

Mounting Options

The Total Access 900e Series may be installed in a wallmount, rackmount, or tabletop configuration.The
following sections provide step-by-step instructions for rack mounting and wall mounting.

Wall Mounting Total Access 900e Series

Follow these steps to safely wallmount the Total Access 900e Series
• To avoid damaging the unit, use only the screws included in the shipment when
attaching mounting ears to the chassis.
• When wall mounting the NetVanta, care must be taken not to damage the power cord.
Do not attach the power cord to the building surface or run it through walls, ceilings.
floors, or openings in the building structure.
• The socket-outlet must be installed near the equipment and must be easily accessible.
Instructions for Wall Mounting Total Access 900e Series
Step
1 Attach the rack mounting brackets rotated 90 degrees so the rackmount tab (two screw holes)
is parallel with the top of the unit (see
2 Decide on a location for the Total Access 900e Series. Keep in mind that the unit needs to be
mounted at or below eye level so that the LEDs are visible.
Warning! The Total Access 900e Series can only be wall mounted with the front panel facing to
the right, to the left, or downward (see the example in
with the LED facing up.
3 Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick)
to a wall stud using #6 to #10 (2.5-inch or greater in length) wood screws.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide
sufficient long-term stability.
4 Have an assistant hold the unit in position as you install two #6 to #10 (1-inch or greater in
length) wood screws through the unit's brackets and into the mounted board (see
page 23).
5 Proceed to the steps given in
22
Total Access 900e Series Hardware Installation Guide
Action
Figure 4 on page
Grounding Instructions on page
Copyright © 2010 ADTRAN, Inc.
:
23)
Figure 4 on page 23). Do not mount
24.
Figure 4 on
64243916F1-34A