Product Label - NETGEAR ProSAFE FS728TLP Hardware Installation Manual

Table 1. LED descriptions (continued)
Port
Twenty-four 10/100BASE-T
ports (one LED for each port)
Note: The LED mode
selector button needs to be in
the Link/ACT mode.
Four Gigabit Ethernet ports
(one LED for each port: 25,
26, 27T, and 28T)
Two SFP GBIC slots (one
LED for each slot: 27F and
28F)

Product Label

The product label on the back panel of the switch shows the hardware model number and
version, the software version, the unique MAC address, and the unique serial number. The
following figure shows a generic product label.
Figure 6. Generic product label
ProSAFE Fast Ethernet PoE Smart Switch FS728TLP
LED Designation
Link/ACT •
•
•
•
•
Link/ACT •
•
•
•
•
Link/ACT •
•
•
•
•
Introduction and Hardware Description
Off. No link is established on the port.
Solid green. A valid 100 Mbps link is established on the
port.
Blinking green. Packet transmission or reception occurs
at 100 Mbps on the port.
Solid yellow. A valid 10 Mbps link is established on the
port.
Blinking yellow. Packet transmission or reception occurs
at 10 Mbps on the port.
Off. No link is established on the port.
Solid green. A valid 1000 Mbps link is established on the
port.
Blinking green. Packet transmission or reception occurs
at 1000 Mbps on the port.
Solid yellow. A valid 10 or 100 Mbps link is established on
the port.
Blinking yellow. Packet transmission or reception occurs
at 10 or 100 Mbps on the port.
Off. No link is established on the GBIC in the slot.
Solid green. A valid 1000 Mbps link is established on the
GBIC in the slot.
Blinking green. Packet transmission or reception occurs
at 1000 Mbps on the GBIC in the slot.
Solid yellow. A valid 100 Mbps link is established on the
GBIC in the slot.
Blinking yellow. Packet transmission or reception occurs
at 100 Mbps on the GBIC in the slot.
11