Replacing The Light Bulbs - GE 197D3354P003 Owner's Manual And Installation Instructions

Ge refrigerators 18, 19 owner's manual and installation instructions
Table of Contents

Advertisement

Available languages

Available languages

Care and cleaning of the refrigerator.

Replacing the light bulbs.

Setting either or both controls to 0 (off) does not remove power to the light circuit.
Some models have only one light.
Pockets
12
Preparing for Vacation
For long vacations or absences, remove
food and unplug the refrigerator. Move
the refrigerator control to the 0 (off)
position and clean the interior with a
baking soda solution of one tablespoon
(15 ml) of baking soda to one quart
(1 liter) of water. Leave the doors open.
Preparing to Move
Secure all loose items such as grille,
shelves and drawers by taping them
securely in place to prevent damage.
Refrigerator Compartment–Upper Light
CAUTION: Light bulbs may be hot.
Unplug the refrigerator.
The bulbs are located at the top of the
compartment near the opening.
Some models have light shields. To
remove the light shield, grasp the shield
as shown with your thumb and index
finger, and gently pull back on the lever.
This will release the shield and allow
you to pull it to the side and remove it.
Freezer Compartment Dome Light
CAUTION: Light bulbs may be hot.
Unplug the refrigerator.
The bulb is located at the top of the
freezer compartment inside the dome
light shield. To remove the shield,
place your fingers in the pockets at
the back of the shield. Pull the shield
forward and down.
Set the icemaker power switch to the 0 (off)
position or move the feeler arm to the
STOP (up) position (depending on model)
and shut off the water supply to the
refrigerator.
If the temperature can drop below freezing,
have a qualified servicer drain the water
supply system (on some models) to prevent
serious property damage due to flooding.
Be sure the refrigerator stays in an upright
position during moving.
Replace with an appliance bulb of
the same or lower wattage.
Replace light shields (on some
models).
Plug the refrigerator back in.
(on some models)
After replacing with an appliance bulb
of the same or lower wattage, replace
the shield.
Plug the refrigerator back in.

Advertisement

Table of Contents
loading

This manual is also suitable for:

1819

Table of Contents