Using The Clock And Timer - GE JSP39SNSS Owner's Manual

Using the clock and timer.

Not all features are on all models.
Clock
Start
On
Make sure the clock is set to the correct
time of day.
Kitchen
Timer
On/Off
Start
On
The timer is a minute timer only.
The Clear/Off pad does not affect
the timer.
18
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of day
cannot be changed during a delayed
cooking or a delayed self-cleaning cycle.
Touch the Clock pad twice.
Touch the + or – pads.
If the + or – pads are not touched within
one minute after you touch the Clock pad,
the display reverts to the original setting.
To Turn Off the Clock Display
If you have several clocks in your kitchen,
you may wish to turn off the time of day
clock display on your range.
Touch the Clock pad once to turn
off the time of day display. Although
you will not be able to see it, the clock
maintains the correct time of day.
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is
9 hours and 59 minutes.
Touch the Kitchen Timer On/Off pad.
Touch the + or – pads until the
amount of time you want shows in
the display. The maximum time that
can be entered in minutes is 59.
Times more than 59 minutes should
be changed to hours and minutes.
If you make a mistake, touch the Kitchen
Timer On/Off pad and begin again.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the Kitchen Timer On/Off pad, then
touching the + or – pads until the time you
want appears in the display.
To Cancel the Timer
Touch the Kitchen Timer On/Off
pad twice.
If this happens, touch the Clock pad twice
and reenter the time of day.
Touch the Start/On pad until the time
of day shows in the display. This
enters the time and starts the clock.
To check the time of day when the display
is showing other information, simply touch
the Clock pad. The time of day shows until
another pad is touched.
Touch the Clock pad twice to recall
the clock display.
NOTE: If the clock cannot be recalled or it
will not stay permanently displayed, the
Energy Saver Mode feature is on. To turn
the feature off, see the Energy Saver Mode
section.
Touch the Start/On pad. The time will
start counting down, although the
display does not change until one
minute has passed.
When the timer reaches :00, the
control will beep 3 times followed by
one beep every 6 seconds until the
Kitchen Timer On/Off pad is touched.
If the remaining time is not in the display
(clock, start time or cooking time are in
the display), recall the remaining time by
touching the Kitchen Timer On/Off pad
and then touching the + or – pads to
enter the new time you want.