Vent; Troubleshooting Tips - GE JSP39SNSS Owner's Manual

Before you call for service...

Troubleshooting Tips

Problem
Display flashes "bAd"
then "linE" with a
loud tone
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
"Burning" or "oily"
odor emitting from
the vent
Strong odor
Drawer does not slide
smoothly or drags
Warming/lower oven
drawer will not work
Excessive condensation
in the drawer
Food dries out in the
warming/lower oven
drawer
Fan Noise
36
Possible Causes
The installed connection
from the house to the unit
is miswired.
A fuse in your home may be
blown, or the circuit breaker
tripped.
The clock is turned off from
showing in the display.
Power failure.
Oven control pads were
not pressed properly.
Power outage or surge.
This is normal in a new oven
and will disappear in time.
An odor from the insulation
around the inside of the
oven is normal for the first
few times the oven is used.
The drawer is out of
alignment.
Drawer is overloaded or load • Reduce weight. Redistribute drawer contents.
is unbalanced.
A fuse in your home may be
blown, or the circuit breaker
tripped.
Controls improperly set.
Liquid in drawer.
Uncovered foods.
Temperature setting too high. • Reduce temperature setting.
Moisture escaping.
Drawer not fully closed.
A convection fan will turn on • This is normal operation of the convection fan.
for 10 seconds during the oven
preheat cycle of the convection
bake and then turn off.
After oven is preheated,
the convection fan will run
continuously in one direction
during convection baking.
What To Do
• Contact installer or electrician to correct miswire.
• Replace the fuse or reset the circuit breaker.
• See the Using the clock and timer and/or the Energy
Saver Mode section.
• Reset the clock.
• The Bake and Broil Hi/Lo pads must be touched
at the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by touching the Clear/Off pad, setting the clock
and resetting any cooking function.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
• Fully extend the drawer and push it all the way in.
See the Care and cleaning of the range section.
• Replace the fuse or reset the circuit breaker.
• See the Warming drawer section.
• Remove liquid.
• Cover food with lid or aluminum foil.
• Cover food with lid or aluminum foil.
• Push drawer in until latch engages.
• This is normal operation of the convection fan.