Advertisement
• It is recommended to stabilize the video camera using
the lens front cap as a platform when performing the
adjustment.
(~
14)
• Touch [COMPLETE].
10
Touch [EXIT] to end the adjustment.
• After adjustment, a single screen appears.
• When re-attaching the 3D Conversion Lens or
after an impact etc., it is recommended that you
perform the adjustment again.
11
Press the recording start/stop button to
start recording.
• When the 3D Conversion Lens is attached, the zoom
position is fixed, and the zoom operation is disabled.
• When recording in 3D, the image will appear with
gray frame around it. The gray frame will be recorded
in the video.
• Use of a tripod is recommended for recording with a
stable picture.
• The reception range for the remote control might
become narrow at the upper side of the video
camera, so operate from the lower side.
• The LCD monitor of the video camera will not display
in 3D.
• You will hear a sound when the video camera is
moved rapidly with the 3D Conversion Lens attached,
but this is not a malfunction.
• When the adjustment dial is rotated too much, you will
hear a "clapping" sound and the adjustment screen
will stop moving. In such a case, rotate the
adjustment dial in the opposite direction until the
adjustment screen starts moving.
• The functions that can be used are limited depending
on the video camera that is being used. For details,
refer to the operating instructions of the video
camera.
To ensure that the 3D video can be safely viewed, pay attention to the following points when recording.
• Where possible, record with the video camera in a horizontal state.
• Do not get too close to the subject. (record from a distance of at least 1.2 m (3.9 feet).)
• When moving the video camera as you record, move it slowly.
• Try to hold the video camera as steady as possible when recording while riding in a vehicle or walking.
18
VQT3A68(ENG)
Advertisement
