Weider Cross Bow By 1500x User Manual page 9

12. Locate the Resistance Bar Fulcrum (18) on the
Lat Tower (4) (see the inset drawing). Slide the
Tray (35) onto the rods on the Resistance Bar
Fulcrum. Make sure the Spacer is oriented as
shown in the drawing.
Set the Resistance Bars into the Tray (35) in the
following order: the 10-pound Removable
Resistance Bar (67), the 20-pound Removable
Resistance Bar (36), an 80-pound Resistance Bar
(95), the 10-pound Center Resistance Bar (44), an
80-pound Resistance Bar (95), and the 40-pound
Resistance Bar (96). Make sure the indicated
rings are on the side shown and the arrows
point toward the Tray.
Orient the Resistance Bar Cover Plate (72) as
shown with the back facing away from the Lat
Tower (4). Attach the Resistance Bar Cover Plate
to the Tray (35) with two M8 x 19mm Button Head
Screws (86).
13. Press two 25mm Square Inner Caps (54) into the
indicated end of the Backrest Frame (15).
Attach a Plastic Foot (53) to the Backrest Frame
(15) with an M4 x 16mm Screw (62).
Orient the Backrest (14) and the Backrest
Backing (8) as shown. Attach the Backrest and
the Backrest Backing to the Backrest Frame (15)
with four M6 x 45mm Screws (58).
14. Insert the rod on the Backrest Frame (15) into the
slot in the Seat Carriage (12). Hold the Backrest
Frame vertically over the Seat Carriage and
slide the rod into the slot, as shown in the
inset drawing.
12
Rings on
this side
35
18
4
18
13
14
8
15
54
14
Rod
15
12
9
86
Back
72
96
44
67
Rods
53
62
58
58
15
Rod
95
95
36
Slot
12