Weider Cross Bow By 1500x User Manual page 14

ATTACHING THE ACCESSORIES
To attach a Short Handle (49) to a high pulley, first
attach the high pulley to the resistance system (see
ATTACHING THE HIGH PULLEYS AND LEG LEVER
on page 13). Then, attach the Short Handle to the
Short Cable (33) with a Cable Clip (51).
The Long Handles (not shown) and the Ankle Strap
(not shown) can be attached to the Long Cable (80)
with Cable Clips (51). Attach the Leg Press Strap (not
shown) to both ends of the Long Cable, or the Lat Bar
(not shown) to the Short Cables (33), with two Cable
Clips.
ADJUSTING THE RESISTANCE
To add resistance, hold a "U"-channel on the 10-
pound Center Resistance Bar (44) firmly and push
the end of a resistance bar under it. Repeat with the
other end of the resistance bar. If more resistance is
needed, add one resistance bar at a time.
Note: When adding resistance, always start with the
heaviest resistance bar to be used, and finish with the
lightest resistance bar. When removing resistance
bars from the "U"-channels, start with the lightest
resistance bar and finish with the heaviest.
WARNING:
ance, make sure that both ends of the resist-
ance bar rest under the two "U"-channels. The
rings on the Removable Resistance Bars (36,
67) must be pushed against the Tray (35). Do
not add or remove resistance bars from the
"U"-channels while an end of the Long Cable
(80) is pulled out.
Note: The resistance system uses progressive resist-
ance. As the resistance bars begin to bend, the
amount of resistance will increase gradually. As the
resistance bars bend further, the resistance will
increase rapidly.
Additional resistance can be added to the resistance
system. To purchase more resistance, call our Cust-
omer Service Department toll-free at 1-888-936-4266
and asking for model number WECCMC0944 (200-
Pound Power Pak).
Note: 1 pound= 0.454 kilograms.
When adding resist-
33
51
49
80
"U"-Channel
67
14
Resistance Bars
35
36
44
"U"-Channel
80