Adjust Oven Thermostat - GE JGBS02EM Use And Care & Installation Manual

Xl44 gas range
Table of Contents

Advertisement

HOW TO CONVE~ THE RANGE FOR USE
WITH
5. To prevent leakage, make sure the orifice
spuds are securely screwed into the gas inlet
tubes. Use a small wrench to hold the inlet tube
hex to prevent it from twisting.
6. Put old ortice spuds back in the bag to save
for possible future conversion.
Note: If an orifice spud is accidentally
dropped, the cooktop
can be raised by
disengaging
blade screwdriver.
attempt to raise the cooktop without
DO NOT
removing all 4 burner bases.
If wires were disconnected to remove the
cooktop, feed wires through the burner holes in
the cooktop. Attach to each burner electrode
terminal carefully, making sure not to bend the
terminal. Then lower cooktop until it snaps
over the clips.
7. Carefully insert burner bases straight down
with the tube over the orifice spud. Replace the
making sure the Ml screw is
screws,
opposite the burner electrode in each
burner base.
42
(continued)
MODELS EQUIPPED WITH DUAL BURNERS
(See
1.
2. Lift burner assemblies straight up and set
aside to gain access to surface burner spuds.
3. With a 7mm
or 5/16" wrench
(depending on the
size of your
spuds), remove
each of the four
spuds on the
surface burner gas
inlet
replace them with
the correct gas
spuds mounted in
a holder at the
right rear of the
range, above the regulator. Natural gas spuds are
brass and LP gas spuds are red or silver. (Mount
the spuds that you removed from the inlet tubes
back in the holder.) To prevent leakage, make
sure spuds are securely screwed into gas inlet
tubes.
4. Replace the burner assemblies.
5. Keep all spuds with your range so you have
them if you move or get a different gas hook-up.
(for Models Equipped with Standing Pilots)
1. Remove the oven
control knob.
2. Locate the thermostat
adjustment screw at left of
thermostat shaft. Turn
screw clockwise until the .-
small pointer is at LP or N,
depending on the type of
gas you are converting to.
3. Replace oven control knob. Q
CONVERTING SURFACE BURNERS OH
Step 3 if range is equipped with sealed burners.)
Lift cooktop.
tubes
and

ADJUST OVEN THERMOSTAT

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents