GE JGBS02EM Use And Care & Installation Manual page 41

CONVERTING SURFACE BURNERS ON
MODELS EQUIPPED WITH SEALED BURNERS (See
Step 4 if range is equipped with dual burners.)
1.
Remove grates, burner caps and burner heads.
2. Remove burner bases by unscrewing the 3
small screws in each base. ~
straight out.
DO N~ disconnect the wires from the burner
bases unless the cooktop needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting with
a 7mm or 5/16" wrench (depending on the size of
your spuds). Apply a 3/4" wrench to the hex
on tie gas inlet tube as a back-up when
removing spud to prevent the aluminum
tube horn twisting.
4. Install or~lce spuds accordin to one of the
following diagrams (see
gas or natural gas, depending on which you are
converting to.
burner
or B ), for LP
orifice for
Spuds
with this Use and Care book. LP orifice spuds
have a 2-digit number and the Letter "L" on
one side. Each ofilce spud will also have 1 or 2
grooves on one side, denoting the location on
the range where it is to be installed.
Natural gas orifice spuds have a 3-digit number
on one side. Each orifice spud will also have 1, 2
or 3 grooves on one side, denoting the location
on the range where it is to be installed.
Front of Range
*o
Natural
(continued next page
41